Cressington 108A Carbon Coater

Description

The Cressington 108A Carbon Coater is typically used for coating SEM samples with less than 20nm uniform coating of conductive carbon. Once pumped down to operating vacuum pressures, a high current is passed through 2 carbon rods. An arc will occur at the point which the 2 rods touch and result in a sputtering-type deposition of carbon. The process, including pump-down, deposition and vent requires approximately 1 minute.

Status

You must first log in to see the status.

Location

Lab - Pettit 161

Capabilities

Deposition - Deposition - Carbon

Shared Drive

No share drive for this equipment.

on this page

contact

• Users
• Trainers

help

• Operating Instructions
• Service Request

Schedule

Schedule Rules:
You can schedule in advance up to 14 days from today
Maximum of 24 hours during peak hours ( Mon-Fri [8AM - 5PM] )
Maximum of 24 hours total per day
You cannot have less than 120 minutes between 2 time blocks.
You are allowed to schedule within the next 8 hours with no penalty. This overrides any conflicting rules listed above.

You must first log in to see the schedule.

Equipment with Similar Capabilities

Hummer 5 Gold/Palladium Sputterer

The Hummer Sputtering System is used to prepare non-conductive SEM samples by coating those with Au/Pd.

Location

Cleanroom - Pettit

Hummer 6 Gold/Palladium Sputterer

The Hummer Sputtering System is used to prepare non-conductive SEM samples by coating those with Au/Pd.

Location

Lab - Pettit 1st Floor

Hummer XP Gold Sputterer

The Hummer Sputtering System is used to prepare non-conductive SEM samples by coating those with gold.

Location

Cleanroom - Marcus Inorganic

Standard Recipes and Reports

You must first log in to see the standard recipe files.

User Shared Files

You must first log in to see shared files.

Billing Rates

There are no hourly rates for this equipment. You will only be charged for cleanroom time.

See our rates for more information.

Service Requests

You must first log in to see service requests for the Cressington 108A Carbon Coater.

Equipment Log

You must first log in to see the equipment log for the Cressington 108A Carbon Coater.

Training Sessions

Choose from the sessions below or request a new time.